SoleMate LogoSoleMate
Select your machine:
SM-76CSM-76A
← Back

Quick Start Guide

Get your SM‑76A up and running in minutes

Get your SoleMate SM‑76A high‑capacity shoe cover machine running in a few minutes. For full details, see the SM‑76A User Manual.

1. Before You Start

  • •Place the machine indoors on a flat, stable, dry floor, away from strong drafts.
  • •Plug only into a grounded outlet (110–220 V AC).
  • •Use only genuine SoleMate SM‑76A film rolls.
  • •Never use the machine barefoot — always wear shoes.
2

Assemble the Handle Bar

  1. 1Insert Handrail B into the bottom case slot and fix it with the four M6 hex bolts using the included wrench.
  2. 2Press Handrail A firmly into Handrail B.
  3. 3Set the machine’s rear wheels into the two half‑slots on the bottom case.
3

Power On

  1. 1Plug the power cord into the machine, then into a grounded wall outlet.
  2. 2Press the power (Enter) key.
  3. 3Allow about 3 minutes to warm up.
4

Load the Film Roll

  1. 1Open the rear cover and smooth any rough edge on the start of the film.
  2. 2Lay the roll horizontally in the film compartment.
  3. 3Guide the film end into the middle of the film outlet while pressing ▲ until it stops.
  4. 4Press the footboard by hand and release — the film moves to the working position.
  5. 5Close the rear cover and set “Reset Remain” to the roll’s count.
5

Apply Shoe Covers

  1. 1Hold the handle bar and step onto the area marked “PRESS”.
  2. 2Hold still until the long beep (about 2–5 seconds).
  3. 3Lift your foot off — the next film feeds out automatically.
  4. 4Repeat with your other foot.

Tips

  • Step straight on and straight off; avoid twisting.
  • Don’t step on the footboard while film is still feeding.
  • If a cover looks loose or incomplete, remove it and apply a new one.
6

If Something Isn’t Working

Machine won't turn on

→ Check the power cord, the outlet (grounded), then press the Enter key.

Film won't reach the working position

→ Press ▼ to back the film out, smooth the film end, and reload while pressing ▲.

Film jam

→ Pull the film out from the outlet and reload. If it is stuck inside, unplug and see Troubleshooting.

Covers loose

→ Keep still until the long beep, clear the bottom vent, or raise Temp. Control by one level.

For more detail, see the User Manual or visit Troubleshooting.

Previous: User ManualNext: FAQ

Need More Help?

Check the full SM‑76A user manual or contact support.